Drywall Master Control Tube Assembly

This Drywall Master control tube is an easy way to replace a worn out control tube. It includes all the rollers and bushings already installed, along with a removeable pull ring for reaching high ceilings. You can take your existing control arm off, and put it on this assembly, or just purchase a new one.

Here is a link to the Drywall Master control arm assembly:

Fits most major brands. 

Installation notes:
The easiest way to swap this out is to:

1. Disconnect the creaser band from the creaser chain.
2. Disconnect the control arm from the existing control tube by loosening the (2) 8-32 set screws.
3. Loosen the tube hardware and straps that are below the control tube and slide off them off, allowing you to then remove and replace the control tube.
4. Finally reconnect the control arm, re-install the tube hardware, and reconnect the creaser band.